diy aquaponics pond | Bettas Pump Replaced

diy aquaponics pond

Having problem with the Betta 6000 pump last few weeks, water flow has drop so much at times its trickling into the growbeds.

Not good for siphon operation, especially these earlier growbeds which uses the 25 mm siphon.

Since I have a spare pump that I did not use, it is best just to reuse it before I get a more permanent solution. So the Resun Penguin pump re installed to the fish tank and in no time the flow is back at full force.

This pump output exceed what is required for 4 growbed, so I had to provide diversion at before the growbeds one on each side of the water feed.

The crayfish tank is using part of the diverted water.

Good flow, but the Resun pump is rated power is more that the Betta 6000 pump consumption.

Do you find information about diy aquaponics pond are you looking for? If not, below may help you find more information about the diy aquaponics pond. Thank you for visiting, have a great day.

Read More..

diy aquaponics system | The Pump Is Dead

diy aquaponics system

On of my pump that running the three barrel CRAFTS set just operate unreliably, it occasionally died and require so knocking to get it going. Remove the pump from the tank and upon close inspection found that the rotor shaft has worn a lot.

Closer look that what the rotor shaft looks like below.

Bought a replacement, same rating of 2000 Liter/hour and this time I ensure that the rotor shaft is made of ceramic.

This Astro 2000 pump set me back RM 40.00, that about USD13.00. I had use this make before and on average it lasted about 3 years.

I would recommend ceramic shaft pump if you can find it, the steel shaft just cant last that long.

Do you find information about diy aquaponics system are you looking for? If not, below may help you find more information about the diy aquaponics system. Thank you for visiting, have a great day.

Read More..